I got this used from a friend for doing some pump tuning. The felt on it was pretty rough so off it came and we polished the aluminum.
Overhead shelf.
Moderators: Greenleaf, BC847, Richie O
16 posts
• Page 1 of 2 • 1, 2
Overhead shelf.
by pulltilbroke » Mon Jul 05, 2010 7:15 pm
Got my overhead shelf in the truck and got my CB mounted and fabbed up a switch panel. Still gotta finish gettin a power source up ther to tie into for all the switches that will eventually be up there. I'm also goin to have a few power ports up there to charge phones and other stuff.
I got this used from a friend for doing some pump tuning. The felt on it was pretty rough so off it came and we polished the aluminum.
I got this used from a friend for doing some pump tuning. The felt on it was pretty rough so off it came and we polished the aluminum.
90 W250 reg cab, Modified knuder valve, reversed reciprocting dinglearm adjusted, High volume flux capacitor,upgraded whirlygig, A clutch and a hitch
93 W350 ext cab dually, getrag and a few adjustments
93 W350 ext cab dually, getrag and a few adjustments
- pulltilbroke
- 14mm rotor
- Posts: 1410
- Joined: Fri Jan 18, 2008 1:20 am
- Location: Eagle Ne
Re: Overhead shelf.
by PJ 3 » Tue Jul 06, 2010 2:32 am
I have been looking at a similar project for my 92.......nice job 
The polished aluminum style looks more professional. Kinda creates a place for the junk on the bench seat also ( in my truck anyway ) 
The polished aluminum style looks more professional. Kinda creates a place for the junk on the bench seat also ( in my truck anyway ) Pete
1992 W250
1992 W250
-
PJ 3 - fuel screw!!!!
- Posts: 220
- Joined: Mon May 18, 2009 4:38 pm
- Location: New Brunswick, Canada
Just run the power wire up behind the plastic on the A pillar. 
