Firstgen1 wrote:i was wondering what you use to cut the insulation with
I used a hoof knife. If I had known it was that soft, i'd have changed it in the parking lot when I was at school....
lift pump part #
Moderators: Greenleaf, KTA, BC847, Richie O
18 posts
• Page 2 of 2 • 1, 2
by dpuckett » Sat Jul 18, 2009 11:31 am
I used a hoof knife. If I had known it was that soft, i'd have changed it in the parking lot when I was at school....
His- 93 W250 club cab LE, auto to Getrag conversion, piston lift pump, 3.54 LSD. 400k+
Hers- 04 QC 4x4. Built auto, Triple Dog, Air Dog. Funny Round truck that aint so quiet.
Hers- 04 QC 4x4. Built auto, Triple Dog, Air Dog. Funny Round truck that aint so quiet.
- dpuckett
- 14mm rotor
- Posts: 2196
- Joined: Wed Jan 03, 2007 4:33 pm
- Location: Perryville MO
by loco one » Mon Jul 27, 2009 7:45 pm
Ace wrote:They are still available on the big auction site. I posted a link to one the other day over at the "den of trolls."
how about posting that link over here ? I also have a ? I"m a little concerned ,I need to be sure I get the right pressure piston pump ! I see a lot of part ### for this pump, which is the right part ## thanks & yes I am researching the stickies !
Locomotive one ,92,cc,le,4x4,nv4500,KDP,oldsmokee power pin, pac ,brake,14w/g,some pump tweeks,
- loco one
- fuel pin?
- Posts: 14
- Joined: Fri Jul 17, 2009 5:08 pm
- Location: flat Sacramento,Ca.
