New truck!
Moderators: Greenleaf, KTA, BC847, Richie O
1 post
• Page 1 of 1
New truck!
by Remps » Thu Jul 29, 2010 5:34 pm
Found a low mile D250 reg cab 5spd yesterday at a dodge dealership, only 104 000 original kms! (its home was that dealership its whole life) No slop in the tranny, truck fired right up with barely a puff and idled smooth after sitting for 6 months. Could drive it 3 feet as it was boxed in, but the clutch and gears work fine. Front bumper is a little bent, and lower front fenders are rusty, and a couple little dings. Put 1/3 down on it, pickin it up in 3 wks. Can't wait to put the 3.07 diff in there,lol!
'90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
-
Remps - 14mm rotor
- Posts: 1130
- Joined: Sun May 03, 2009 12:57 am
- Location: Saskatchewan
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 62 guests