hey-Hey!!!,
What size is the banjo on the fuel filter inlet? I think it is 12mm( but that is just 'net research ), and I'd like to know for sure. Going to put an electric pump on and use a banjo-to-barb fitting to simplify the process a bit.
cheers,
Douglas
Fuel filter inlet banjo
Moderators: Greenleaf, KTA, BC847, Richie O
5 posts
• Page 1 of 1
Fuel filter inlet banjo
by Douglas » Mon Sep 13, 2010 3:20 am
1990 D250, NV5600, 16cm housing and PAC brake, Powr-Lok'd 3.07's, HX35...IC next
1991 D250, 727 and 16cm H1C.
1991 D250, 727 and 16cm H1C.
- Douglas
- fuel screw!!!!
- Posts: 312
- Joined: Tue Feb 23, 2010 10:25 am
- Location: Ann Arbor, MI
Re: Fuel filter inlet banjo
by Remps » Mon Sep 13, 2010 6:05 am
Pretty sure its 13 mm. I drilled mine out to 11/64, and sealed them with the old copper gaskets no prob. I had new gaskets on hand just in case. Drilling them any bigger weakens the bolt too much. Also the bleeder bolt on the fuel filter outlet banjo protrudes into the flow area, so I shortened it as well.
'90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
-
Remps - 14mm rotor
- Posts: 1130
- Joined: Sun May 03, 2009 12:57 am
- Location: Saskatchewan
