by mitchk » Sun Feb 23, 2014 10:47 am
So i got the 3200 spring in yesterday and oh man did that wake her up. the only thing is i cant get the idle down below about 1000 rpm. i was reading up yesterday and all i could really find just said to reindex the throttle lever on the shaft. is that the proper way to adjust it or could there be another problem causing the high idle. The idle screw isnt even touching the throttle lever anymore and when i put the throttle lever on the shaft i had to do it acouple times just cause of ocd and i wanted to make sure it was staying in the right place. thanks
Daily: 91 d350 727 gear vendors over drive, 3/8 feed line, THD lplp, maxed pump, Denny t 2, timing to head, #366 spring, 60# valve springs, arp studs, 60 horse injectors?(po), THD bahf, s362sxe
Project: 93 w250 5 speed, ground stock pin, #366 spring, 60# valve springs, THD lplp, intercooled compressor non intercooled turbine, diamond eye 4 inch, custom intake, south bend hd single