24v intake horn on 1st gen

How to make it go fast

Moderators: Greenleaf, KTA, BC847, Richie O

24v intake horn on 1st gen

Postby Kasper Cummins » Sun Jun 15, 2014 6:06 pm

A 2 foot tubing bent at 45°s, trim 2.25" off the intercooler end of the tubing. It will need a ring welded around each end or a bead roller would look cleaner, but it will be cover by the boot. Then just install, it will look like this.

Image

This is without a grid heater. Hope this helps people.
I know my truck needs a cleaning.
92 W250 club cab

Kasper Performance Fabrication
Kasper Cummins
fuel screw!!!!
 
Posts: 163
Joined: Mon May 09, 2011 7:14 pm
Location: Sauk Center, MN

Re: 24v intake horn on 1st gen

Postby RCCUMMINS89 » Sun Jun 15, 2014 8:18 pm

I've got the same thing.... Thank you for posting this though.
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID


Return to The good stuff

Who is online

Users browsing this forum: No registered users and 16 guests