What PSI lift pump do i need?

[rollieD250]

(I did search for this)

Getting ready to order a 2nd gen lift pump from the hungry diesel and i have 2 options as im sure most of you guys know 15 or 18psi

Going to be running a 57/65/14, 5x12's, timing spacer, fuel screw, pin and 3200 spring in the near future

Thanks alot guys

[AHineman]

Either one would be fine. I personally would go to the higher side, but 15 would keep up with that setup easily. It's not a bad idea to run bigger line from the tank up as well if more power is in your future.

[1992gen1_fan]

If you go with the higher psi pump its recommended to loctite the front seal in the IP especially if its an older IP.

[AHineman]

Anything you change from stock is obviously at your own risk, but 18 or 20 psi wouldn't scare me on a stock front seal.

[rollieD250]

Thanks guys i think im going to go with the 15psi for now should be able to make 300hp with it

[RCCUMMINS89]

The 15 psi will supply pretty much any setup. Unless one has very large injectors. Teh 15 maintains good pressure with my 5x17.