Build list

How to make it go fast

Moderators: Greenleaf, KTA, BC847, Richie O

Re: Build list

Postby fatty » Thu Apr 02, 2015 2:50 pm

I just checked my PayPal and I paid him $255 shipped. It comes with EVERY seal and gasket needed. And a few extras because it will also fit different applications of 12 valves.
91.5 w250
fatty
14mm rotor
 
Posts: 802
Joined: Tue Nov 04, 2008 8:52 pm
Location: Washington

Re: Build list

Postby Remps » Wed Apr 15, 2015 2:37 pm

Last 3 weeks of work have been really slow, 46.5 hrs in last 2 weeks. Was going to order some parts tomorrow, but better make sure I can make rent at the end of the month. :sad: did an oil change a couple days ago on the 96, one bottle of Lucas stop leak, one bottle of Lucas oil stabilizer, 4 litres of 5-40 synthetic, and 6 litres of 15-40. Smoothed it out quite a bit, must have brought compression back up on #6 some. It was starting to shake pretty good when putting any load or rpms on it before the oil change.
'90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
User avatar
Remps
14mm rotor
 
Posts: 1128
Joined: Sun May 03, 2009 12:57 am
Location: Saskatchewan

Previous

Return to The good stuff

Who is online

Users browsing this forum: No registered users and 16 guests