New Era Injectors

[NEW ERA]

They are in and ready to be cut. Call in and make sure you are on the list. They will not last long.

[Crossy's son]

Price on 5x.012's for a 1st gen? with cores ?

thanks

[NEW ERA]

Here is some pricing to help a little. I will buy cores for 15.00 each if you want to sell them but we are no longer using them.

300's thru 370's 700.00

435's 825.00

6x16's 900.00

These prices are for 1st and 2nd gen 12valves.

Chuck Rucker
New Era Diesel
740-819-0457

[Begle1]

Holy Crap, somebody raised prices.

That due to core problems?

[NEW ERA]

Yes it was due to cores. We are no longer building them with core injectors. We are now using new remans. We are still lower than the others that use remans. Just not as low as the ones that are just cuting tips and setting pop pressures. This is going to make a better injector in the long run.

[Hoss]

I think thats a smart move and the only way to insure a quality product. I'll be savin my pennies for a set of 370's!

[NEW ERA]

We have debated on doing it this way for awhile now. I know the price is a jump. But if you know the old prices and look at the new ones its not that bad being that they are new injectors and not just cores that we have went thru. Granted we did not have trouble with our old way, but these are going to be alot better.

[sdubfid]

What is the spray angle on these?

Thanks

[NEW ERA]

145 We keep stock angles unless, customer wants different.

[Richie O]

Are the angles the same between the Non i/c and factory cooled trucks?
( I know the non has 9mm and cooled has 7mm). Just wondering on the spray angle. ( I always see this question )

[NEW ERA]

You know I will have to check that. We always sell the 7mm with the adapters so if the head every go's they can put on a newer one, without buying new injectors.

[CHEMMINS]

What about a set of 6x12's? Kinda falls inbetween yer pricing.

[NEW ERA]

What about a set of 6x12's? Kinda falls inbetween yer pricing.

They would fall in the 825.00 range. The 6x12 is just a touch bigger than the 435

[peobryant]

Tis may be posted somewhere, but I haven't seen it so I'll ask. Do you all extrude hone, or EDM your injectors?

[CHEMMINS]

What about a set of 6x12's? Kinda falls inbetween yer pricing.

They would fall in the 825.00 range. The 6x12 is just a touch bigger than the 435

My math may be off but.

370's

3.14*((0.5*.012)(0.5*.012)) * 5

= 0.0005652

--------------------------------------
6x.012

3.14*((0.5*.012)(0.5*.012)) * 6

= 0.00067824
--------------------------------------

435's

3.14*((0.5*.014)(0.5*.014)) * 5

= 0.0007693