Good Luck, glad I could help on the injectors!
Do you plan on going to SOP this year? If so, I'll see ya there!
Injector advice?
Moderators: Greenleaf, KTA, BC847, Richie O
16 posts
• Page 2 of 2 • 1, 2
by PToombs » Sun May 20, 2007 7:05 am
If the lines are leaking try to loosen then tighten them again. DO NOT torque them tighter and tighter! Or you can loosen them and try to make sure they are straight when you tighten them. I usually do the loosen/ tighten with it running, if there is a little crud in there it will blow out.
Good Luck, glad I could help on the injectors!
Do you plan on going to SOP this year? If so, I'll see ya there!
Good Luck, glad I could help on the injectors!
Do you plan on going to SOP this year? If so, I'll see ya there!
pete
Just enough power to break everything behind the crankshaft.
Just enough power to break everything behind the crankshaft.
-
PToombs - 14mm rotor
- Posts: 11367
- Joined: Sun Jan 07, 2007 6:13 pm
- Location: Syracuse NY. Snow central!
16 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 31 guests