3200 RPM spring question

[Billy Bones]

So I'm still new to Cummins and I am looking into getting a 3200 rpm gov spring but don't know where I should go for price and quality I've heard of guys getting springs from all over the place and all sorts of prices. I'm hoping I could get a few opinions where I should look to buy, quality and price. Has anyone heard anything about this one? Thanks!

http://www.ebay.com/itm/3200-RPM-BOSCH- ... 6241306%26

[skilletky]

It's a Bosch. Buy it. Learn about putting it in before you do it

[cmann250]

There's a series of videos about the 3200 spring install on Youtube. 91CTD is the guy's username on Youtube I think. He goes a really good job of explaining everything.

[PToombs]

They are usually between $16 and $20, I wouldn't worry about the quality if it says it's a Bosch part.

[Billy Bones]

Cool I don't know how I missed that it was a Bosch part thanks guys!

[Mustangracer42]

I was searching for this same info. Thanks for answering my question too.

[1stgenFummins]

i just did mine, i had the head off so it was a lot easier. I think the biggest thing is just to make sure your pump is extremely clean on the outside before you remove the pump top. Dirt could easily fall down in there and cause some havoc. I used the videos on youtube and reading the treads on here to help point me in the right direction. Overall this is a really easy mod to do and cheap. Good luck man

[1stgenFummins]

it also might not be a bad idea to pick up a pump gasket kit from a bosch dealer p/n DGK 121