Moderators: Greenleaf, BC847, Richie O
PToombs wrote:Were you cutting on the 1/2" side or the 2" side? I've found that if you set it upright and cut the skinny way it cuts faster than laying it flat and cutting it. The other thing is if I have to cut something wide it will start to cut and then slow down, so I lean into it some more and it starts cutting faster again. I think the metal gets hard from the heat and you need to force it thru that spot.
PToombs wrote:I was thinking about this today while I was cutting something at work. Matthew said the thinner blades heat up and it warps. I think it cuts crooked when you apply too much pressure and it flexes the blade.
Users browsing this forum: No registered users and 13 guests