2015 BS and Chat Thread!

[RumbleFish]

Ft wayne clutch is good. And i know sonebody kinda local to there!

[cmann250]

I'll have to call them. I'm not sure its feasible to drive out there, but I bet they can get me parts.

[cmann250]

Philip saves the day! I checked at Rowe on a whim and they had what I needed for $27 vs the $40-some that Quad wanted. Local shops for the win!

[DMan1198]

So I went for blood tests the other day. doctor called yesterday concerned about my cholesterol. It won't really be much of a surprise if it's high though as it's somewhat common on my moms side. As long as the ratio between good and back is good I don't think I'll change anything.

[Philip]

Philip saves the day! I checked at Rowe on a whim and they had what I needed for $27 vs the $40-some that Quad wanted. Local shops for the win!

I forgot Rowe had a shop down there. All I think of is the one in Kokomo.

I knew anyplace would be better than quad$X$. I delt with them one time. That was enough to last the rest of my life. I'll buy from autozone before I would call them.

[txs]

I don't think the kokomo rowes does driveshaft work, I think it all goes over to Lafayette, they did my front and rear shaft when I put in the six speed, been over 10 years now, no problems.

[cmann250]

I don't think kokomo does, they don't seem to have the space.

[DodgeFreak]

anyone know where to get a set of cheap 18.4-38 tractor tires??? Around Iowa preferably. One of dads went bad I can get Titan tires for 684 a piece but dad can't hardly justify that since we only use it maybe 10 hours a year if that.

[DMan1198]

Road trip by myself to Montana this weekend starts tomorrow. Going to visit my cousin, and her 6 month old girl. Then it's only 5 and a half hours to Corvallis

[fatty]

Corvallis OR? What you doing down there?

[DMan1198]

Corvallis Montana. Visit my best friend

[ellis93]

Anyone here work on land rovers? I'm working on now,installing an engine in place of one that was crispy crittered by a woman.
What a POS! It took me 2hrs to get all the bell housing bolts out and almost as long to get them back in with the wiring harness brackets back on. What a world of stupidity. They have room every where else but at the cab fire wall and floor board pinch point. I guess your supposed to remove engine and trans as an assembly or something. Dumb!

[RumbleFish]

Too bad you aren't getting paid by the hour at that pace.

[ellis93]

Tell me about it! The job only calls for 10.some odd hours. Ridiculous!
It's done now and I won't ever touch another landrover discovery again. That's a profound discovery for sure.

[PToombs]

Learning curve, fasten your seat belt!

Man it's cold here today! Only got up to about 6 or 7*. Glad I had an inside job. I didn't even bother to start the truck, I took the old ladies car to work, it gets heat faster and gets better mileage.