new project, new to 1st gens

Stop in and say hi

Moderators: Greenleaf, BC847, Richie O

new project, new to 1st gens

Postby Wooderson » Sun Jun 07, 2015 9:35 am

Hello everyone

Thanks for having me here. Seems like a really good bunch. After wanting a 12V for 20 years I finally got one and am pretty stoked to start playing with it. This is my first Dodge I have ever owned and even though its only a partial, I have always liked 1st gens. Still in the early mock up stages but so far things are going well. I'm trying to mate a 1947 Mercury 1 ton onto a 1991 D250 chassis. After measuring different frames this one I thought would work the best because the narrow frame width lends itself well to the long nose of the Mercury. And of course it has a Cummins built into it. The donor D250 pedals, brakes, etc should all work fairly well too. Will be lowering the truck as well. I can already see that there are challenges ahead in that department in the front especially but hopefully can make it happen. Look forward to sharing the project and learning about these trucks from you guys.

Image

Mark
1947 Mercury 1 ton sitting on 1991 D250 chassis 6BT 5 spd
2002 Ford F350 7.3L Powerstroke 4x4
1966 Ford F100 Ranger 547 C6
2007 Toyota Tacoma SR5 4x4
Wooderson
smoke screw?
 
Posts: 1
Joined: Sun Jun 07, 2015 8:37 am

Re: new project, new to 1st gens

Postby RCCUMMINS89 » Sun Jun 07, 2015 9:56 pm

Welcome. Way cool.
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4821
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID

Re: new project, new to 1st gens

Postby ellis93 » Mon Jun 08, 2015 4:35 am

Welcome!
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7731
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi
Top

Re: new project, new to 1st gens

Postby Ready2Go » Mon Mar 14, 2016 4:51 pm

Looks like a fun project, please share your progress
1989 Stock D250 LE
Ready2Go
smoke screw?
 
Posts: 4
Joined: Sun Mar 13, 2016 6:52 am
Location: Labrador City, NL
Top


Return to Welcome

Who is online

Users browsing this forum: No registered users and 1 guest