Moderators: Greenleaf, BC847, Richie O
matthewh wrote:I'm sure Ellis will be by shortly to.welcome you, and I believe his Cummins powered Chevy is a 24v with a VE. Check out his build thread under conversions and builds
1towman wrote:matthewh wrote:I'm sure Ellis will be by shortly to.welcome you, and I believe his Cummins powered Chevy is a 24v with a VE. Check out his build thread under conversions and builds
Will do and thanks for the heads up about Ellis and his truck. I see so many post on putting a Ppump on and hardly any on doing what I want to do so it's always helpful to see what others have done and how they did it.
ellis93 wrote:1towman wrote:matthewh wrote:I'm sure Ellis will be by shortly to.welcome you, and I believe his Cummins powered Chevy is a 24v with a VE. Check out his build thread under conversions and builds
Will do and thanks for the heads up about Ellis and his truck. I see so many post on putting a Ppump on and hardly any on doing what I want to do so it's always helpful to see what others have done and how they did it.
Ellis since I'm new it's not letting me pm you so maybe you could contact me when you have a minute.
thanx, ben
BTW how many post does it take to be able to navigate around this site?
The deciding factor for me was the 500$ lines. Screw that. No way in hell do they cost 500$ to build....
Only thing that was hard to find was the line adapters.....I found them and they're referenced in my tread. Only thing about those is I had to trim the length of them for the line nuts to seat properly. I bought mine either on amazon or eBay.
If your going to try and use the 24v injectors......leave them alone,run them as is. The factory 24v injector is a 7hole variant and if you lower the pop pressure to the VE's 245bar I believe you'll wind up with idle haze. I don't know that for certain (haven't done it with this 24v) but in a 12v they do in the cold. Once warm.....they're ok.
I've put close to 9500 miles on the Chevy and 24v now......injectors at whatever worn injectors are at,at 200k factory injectors,no issues from the rebuilt injection pump.....knock on wood.
Whatever else you need to know.....pm me or post up here,anywhere. I'll be glad to share whatever knowledge I have.
Users browsing this forum: No registered users and 17 guests