This is for my Ramcharger but since the axles are the same I figured itd be ok to ask here...
I have a D60 rear from a 76 W200 lsd 4.10 and a D60 front from a 92 W250 3.54.
I went to swap the yoke on the rear 60 and the pinion bearings are gone, half inch of slop at least. I didnt pull the rear cover yet, I was so pissed I had to walk away.
So Im looking at a full rebuild of the rear, and a regear on the front (3.54 to 4.10). Is this doable as a shadetree gearhead? I dont have the deal to spread the housing, a shop press or bearing pullers. Are there practical work arounds? Also, how hard is it to redo the shims for gear mesh?