Help me spend my money!

How to make it go fast

Moderators: Greenleaf, KTA, BC847, Richie O

Re: Help me spend my money!

Postby spencerdiesel » Thu Sep 27, 2018 6:52 pm

Lol that would be about my luck too
1992 W250, 5 speed, 4.10, Ext. cab Ext. bed, 12.5k winch, 75 gal. fuel tank

H1C/18

Fuel: THD 6x10 VCO sticks, THD 12 psi piston pump, THD fuel pin, 366 spring, fuel screw 2 turns in, timing to the head/ >1/4”
Muffler delete

Minimum 60% WMO full time since Sep. 2018
spencerdiesel
14mm rotor
 
Posts: 1106
Joined: Tue Oct 27, 2015 4:02 pm
Location: Brevard, NC

Re: Help me spend my money!

Postby Remps » Sat Sep 29, 2018 11:50 am

Is that a Hamilton head? Are you doing a cam swap as well?
'90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
User avatar
Remps
14mm rotor
 
Posts: 1128
Joined: Sun May 03, 2009 12:57 am
Location: Saskatchewan

Re: Help me spend my money!

Postby laneends » Sat Sep 29, 2018 5:27 pm

Yes and yes! Hamilton head, and a 188/220 cam. Just realized today the fuel heater will be going away...
1990 D-250 with getrag 360: pyro, boost, volt, oil pressure, fuel pressure, and water temp gauges, hot screw, 366 gov spring, THD pin, M&H dynamic timing spacer, throttle linkage adjusted for full travel, 4" turbo back exhaust, THD's LPPLP, BHAF, south bend clutch. THD 5x13 comps, 362sxe, 3" crossover, pump to the head
User avatar
laneends
fuel screw!!!!
 
Posts: 53
Joined: Sat Sep 26, 2015 1:50 am
Location: Kent washington/Bearing Sea
Top

Previous

Return to The good stuff

Who is online

Users browsing this forum: No registered users and 11 guests