by CumminsPower59 » Sun Jul 08, 2012 7:02 pm
I went to a wrecking yard a while back and measured some take out rear bench seats, most are 20" deep, while the Ford unit that I mentioned earlier was 16", so there is a little more room. The best way to measure is the distance from the rear wall to the rear of the passenger seat as there is no fore/aft movement of that seat. I measured it a while back, but can't remember the exact measurement right now. The rear bench seat that I have is an aftermarket unit that was made for our trucks, it is the only one that I have ever seen, so I bought it immediatley. I can post some pictures of it up tomorrow if you want to see what it looks like.
Ike
91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed