Is the comp wheels the same??? I robbed the comp wheel off one of my hx35s for mock up of my 351 but I'm wanting to put the hx35 in my truck So I was thinking about using the h1c wheel if it was the same...
if not I'll pull the hx off and use the h1c for mock up. Also the turbine wheels are the same between the two correct???
H1c and HX35
Moderators: Greenleaf, KTA, BC847, Richie O
3 posts
• Page 1 of 1
H1c and HX35
by DodgeFreak » Fri Feb 28, 2014 12:09 pm
92 D350 Cab and Chassis. Auto stock, wiring gremlins. 330k miles
92 W250 Ext cab rotted completely out. Auto, pump maxed, 215 ppump nozzles, Denny T2 pin.
85 D350 single wheel, converted to cummins, getrag, turned up 2 turns and afc screw flush.
92 W250 Ext cab rotted completely out. Auto, pump maxed, 215 ppump nozzles, Denny T2 pin.
85 D350 single wheel, converted to cummins, getrag, turned up 2 turns and afc screw flush.
-
DodgeFreak - 14mm rotor
- Posts: 1701
- Joined: Sat May 15, 2010 8:14 pm
- Location: Iowa
Re: H1c and HX35
by ellis93 » Fri Feb 28, 2014 1:22 pm
Nope......h1=54 hx=56. An actual "w"h1c is the exact same wheel as a hx tho.
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
-
ellis93 - 14mm rotor
- Posts: 7762
- Joined: Wed Feb 17, 2010 3:16 pm
- Location: lucedale,mississippi