by thrashingcows » Wed Oct 29, 2014 10:01 pm
Well that would do it.
I just recently replaced my passenger side power mirror since the lens had broken, and previous owner installed a plastic stick on lens many moons ago that was faded and warped.
Anyway I went with one of the aftermarket units. Was good except the main body mount cover...the chrome piece on the door would not slip down cleanly. I could not get the lower set screw to even start...sat out too far. Also I did not like the way the "new" bracket fit on the door...so I swapped the old bracket, and lower cover from the old unit. And everything fell together after that.
The main mirror, chrome mirror shell and wiring all were fine, and works good.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.
Check out the build....
http://www.dieseltruckresource.com/dev/ ... 05923.html