
The grab handle is from a 2nd Gen ram...exact location and trim line I do not know. I hot a few wreckers locally but could not find it. I jumped on E-bay and found one within a few minutes.
Here is a pic of the unit....from the thread on DTR. (forgot to grab one of mine)

First remove your trim and pillar cover. I used a spare unit...in OK shape..been dyed a few times and was warped a bit. I Did not want to cut up the nice grey unit (Hoarding for later).

Then on the flat portion of the metal pillar decide where you want it located.

Inner holes are 1/4" and the outer holes are for the screws. Next take a bunch of measurements and transfer those to your plastic cover. now grab some files and start working on them.
Should look something like this....

