radiator shroud diameter ?

How the engine works

Moderators: Greenleaf, KTA, BC847, Richie O

radiator shroud diameter ?

Postby jethro » Tue Jul 14, 2015 11:47 pm

I am building my radiator shroud. It is a sheet aluminum pyramid out of .062 6061.
I added a 3/4 inch angle frame around the edge on all 4 sides to slide into rad.
I am about to cut the circular hole to put in a duct type thing .
I would like an opinion(s) on how much clearance I should allow between the tip of the blades
and the inside of the tubular shroud ???????

I was thinking of an inch might be enough....... but I figure it will depend on just how much the
engine sways left to right under torque .... (which I don't know how much that will be....... )
I am using destroked motor mounts.

Any thoughts much appreciated !

fuel screw!!!!
Posts: 418
Joined: Sat Mar 08, 2014 12:32 am

Re: radiator shroud diameter ?

Postby wilkyflex » Thu Jan 31, 2019 4:05 pm

Tim, what's the name of that cardboard sheet like part that covers the gap between the front of the radiator and the body? It's as long as the radiator and about 5" wide, and 1/8" thick. Tools go there when you're working on the truck. I can't figure out the name of that part?
fuel screw!!!!
Posts: 37
Joined: Mon Sep 06, 2010 10:01 am

Re: radiator shroud diameter ?

Postby PToombs » Thu Jan 31, 2019 6:31 pm

Baffle, Radiator Diesel Engine. Part number 4266 769

Just enough power to break everything behind the crankshaft.
User avatar
14mm rotor
Posts: 11258
Joined: Sun Jan 07, 2007 6:13 pm
Location: Syracuse NY. Snow central!

Re: radiator shroud diameter ?

Postby thrashingcows » Tue Feb 19, 2019 3:57 am

DMT have reproduction ones, they sell them on E-bay for about $15.

https://www.ebay.com/itm/DMT-Mopar-91-9 ... ctupt=true
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.

Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
14mm rotor
Posts: 568
Joined: Wed Nov 02, 2011 12:00 am

Return to Engine

Who is online

Users browsing this forum: Black93 and 6 guests