1stGen.org

by **fergavs** » Sun Jun 08, 2008 2:19 pm

What diameter are the wooden dowls I need to insert in the lifters while doing a cam swap?

by **CumminsPride** » Sun Jun 08, 2008 2:58 pm

by **PToombs** » Sun Jun 08, 2008 5:08 pm

They work good too. I saw pics on another site.
Or you can use Vice Grips like someone on here who shall remain nameless.

by **cummins king** » Sun Jun 08, 2008 6:50 pm

smart a$$

by **PToombs** » Mon Jun 09, 2008 4:58 pm

That's my job buddy! :jocolor:

I wasn't gonna tell him, you gave yourself up! :jumpsmile:

by **mprmn08** » Mon Jun 09, 2008 5:06 pm

not only vise grips but 2 battery charger clamps also. he's high tech!! :wrench:

by **cummins king** » Mon Jun 09, 2008 7:57 pm

I know its just your job, haha

Its okay i still laugh about it with my budy

Joel

by **seeker1056** » Tue Jun 10, 2008 6:05 am

ok smarteepanz

how do you get the lifters outa the block without droppin them in the pan after u get the cam out

by **PToombs** » Tue Jun 10, 2008 4:13 pm

Take a piece of PVC or thin pipe, cut lengthwise in 1/2. Slide in the cam hole, grind a washer so it just wedge fits in the lifter with a little pressure. Tie a string to the washer. Drop the lifter/ washer combo into the tray, pull it out. When you install, put the washer in the lifter, slide tray in, pull string up, lifter goes in hole. :tongue:

Mess with the best, get smoked like the rest! :finger:

by **cummins king** » Tue Jun 10, 2008 8:18 pm

smart thinking budy, im liking those ideas

but i just had to get the cam out so i didnt care if they droped or not

by **PToombs** » Wed Jun 11, 2008 5:06 pm

I know what you mean. I just figured he was replacing them.

1stGen.org

wooden dowls for cam swap?

wooden dowls for cam swap?

Who is online