Last truck now has gauges
Moderators: Greenleaf, KTA, BC847, Richie O
17 posts
• Page 2 of 2 • 1, 2
Re: Last truck now has gauges
by manyholes » Sat Feb 26, 2011 6:02 pm
is the pod on the 89 just a generic 2 hole pod?? pyro and boost are my main concerns and i can always mount a couple down low for others like fuel pressure.
1990 W250 dodge ex cab, LB, work in progress. truck was originally reg cab/lb, ex cab is an add on.fuel pin turned, 30psi, bhaf, straight piped 3", new rear springs with shackle flip, 4" lift front, crossover steering, waiting on piston lp, c/c s/b conversion, turbo upgrade and intercooler install
- manyholes
- fuel screw!!!!
- Posts: 83
- Joined: Sat Oct 16, 2010 8:30 pm
Re: Last truck now has gauges
by Richie O » Sat Feb 26, 2011 7:22 pm
No it is an autometer brand pod made for the dodge 1st gen. Its a partial pillar pod. Make sure you get the " AUTOMETER " brand one as the other brand floating around has the gauges pointing at the sky.
1989 W250 727, 3.07 L/S, S300, P/S Intercooler, Stans exaust, Pump adjustments, 127k miles,297 hp
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
-
Richie O - Administrator
- Posts: 4171
- Joined: Sat May 17, 2008 9:01 pm
- Location: New England