1stGen.org

THE place for 1st gens

Skip to content

industrial injection ve pumps

How to make it go fast

Moderators: Greenleaf, KTA, BC847, Richie O

Post a reply

industrial injection ve pumps

Postby Diesel Dawg » Fri Aug 05, 2011 10:29 am

Does anyone have experiance with them? My VE is getting weak I think because it does not idle as fast when warm out. Just checking about replacing it.
92 D-350 reg. cab,dually,c.t.d.,auto,3.54s,fuel screw 2+turns,smoke screw3 turns,star wheel all the way down,,B.H.A.F.,,gauges,DennyT stage 2 pin,366 spring next!!!
User avatar
Diesel Dawg
fuel screw!!!!
 
Posts: 71
Joined: Fri May 29, 2009 12:51 pm
Location: Hugo,Ok.
Top

Re: industrial injection ve pumps

Postby Diesel Dawg » Mon Aug 08, 2011 1:16 am

bump bump bump
92 D-350 reg. cab,dually,c.t.d.,auto,3.54s,fuel screw 2+turns,smoke screw3 turns,star wheel all the way down,,B.H.A.F.,,gauges,DennyT stage 2 pin,366 spring next!!!
User avatar
Diesel Dawg
fuel screw!!!!
 
Posts: 71
Joined: Fri May 29, 2009 12:51 pm
Location: Hugo,Ok.
Top

Re: industrial injection ve pumps

Postby Remps » Mon Aug 08, 2011 7:02 pm

I have one, still in the box though. I know there is one guy on dieselbombers that has one, don't remember reading anything negative about it. They are cheaper than some other places, I paid 1600 no core, I think I coulda got 600 back with a core.
'90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
User avatar
Remps
14mm rotor
 
Posts: 1130
Joined: Sun May 03, 2009 12:57 am
Location: Saskatchewan
Top
Post a reply

Return to The good stuff

Who is online

Users browsing this forum: No registered users and 28 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
cron