Non-I/C turbo selection/modifications????

[Hansen01]

Being hot, with every bottomed and the fuel screw just affor runnaway i could hit 1600. now i got the full power screw out 2 turns and it wont climb bast 1200 degrees

[JustinRhodes]

Did you get for 5spd swap done?

[1990BamaCummins]

My pump is turned up but not bottomed to run away. Im talking to a guy who has an hx35 with a 16cm housing so i dont think EGT's would be bad with what im runnin now. I dont have gauges on it yet (have em just not in yet) and im not concerned about the EGT's.

Just looking for a good turbo to bolt on to get some more air to my engine and something thats going to increase the overall capabilities of my truck. I think i have plenty of fuel to get more out of my truck.

I appreciate everyone keying in on my thread and the info. Its helped alot so far and with my own research and seeing what others are running with similar mods as my truck.

Thanks so far guys. Keep the thoughts and info coming.

[1990BamaCummins]

Hey Justin, yea almost done with the swap, just trying to get some bushings for my trans to cross-member mounts.

[01hillbillycummins]

let us know what you end up doing, im in the same boat. my truck is a little less modded though

[1990BamaCummins]

Im gonna go with an hx35 with a 16cm exhaust housing and see how i like it. Purchasing one from a guy and gonna try it out. If i dont like it, ill re-sell it.

[01hillbillycummins]

anybody know where i can get a super hx40 at?

[1990BamaCummins]

There was a guy on here "delinquient" I think selling one and i think another guy selling one on cummins forum also. I got the hx35 on mine now, havent run it yet but i think its going to do what i want and run good for my set up.

[cmann250]

anybody know where i can get a super hx40 at?

Search "super40" on this site. I know the part number fom Turbo Supply is floating somewhere around here