Need Help on non intercooled injectors

How to make it go fast

Moderators: Greenleaf, KTA, BC847, Richie O

Need Help on non intercooled injectors

Postby 91bluecummins » Sun Feb 26, 2012 7:47 pm

Im thinking about putting injectors in my 90 (project truck) and a 60mm compressor upgrade. What is the best size injector to get 5 hole, 6 hole or what .To get a good boost in power and not grenade the turbo. And what is a good brand that are not to expensive sdx, ddp,so no. i was thinking about a 5x.014 sac but what do y'all think. I appreciate it
92 cummins W250 extenged cab (The Goat) project truck
90 cummins W350 single cab dually flat bed 5 speed, he351ve 62mm
1959 chevy Apache 4bt cummins 4 speed
User avatar
91bluecummins
fuel screw!!!!
 
Posts: 150
Joined: Fri Jan 01, 2010 3:07 pm

Re: Need Help on non intercooled injectors

Postby CumminsPower59 » Sun Feb 26, 2012 8:06 pm

Stock N/IC sticks are pretty decent size and good amount of power can be had with them. IIRC they are 4x13's.

5x14's are pretty big, you'll need more air than a 60mm compressor upgrade to cool them ;)
Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
CumminsPower59
14mm rotor
 
Posts: 3203
Joined: Mon Feb 25, 2008 8:04 am
Location: The Hawkeye State of 'Murica!

Re: Need Help on non intercooled injectors

Postby ellis93 » Sun Feb 26, 2012 8:18 pm

Check out JKidd's injectors on diesel auto power. He's got pretty good prices on them. I've also done some searching on them and I've found very little saying problems with them.
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7762
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi
Top


Return to The good stuff

Who is online

Users browsing this forum: No registered users and 36 guests

cron