Wastegate actuator ?
Moderators: Greenleaf, KTA, BC847, Richie O
17 posts
• Page 2 of 2 • 1, 2
Re: Wastegate actuator ?
by DodgeFreak » Fri Feb 28, 2014 6:44 pm
That housing is the same as the hx35 I have with a different actuator. Now I can't seem to get the back off lol so I'm not sure if you can reclock the gate because instead of being straight down its sideways.
92 D350 Cab and Chassis. Auto stock, wiring gremlins. 330k miles
92 W250 Ext cab rotted completely out. Auto, pump maxed, 215 ppump nozzles, Denny T2 pin.
85 D350 single wheel, converted to cummins, getrag, turned up 2 turns and afc screw flush.
92 W250 Ext cab rotted completely out. Auto, pump maxed, 215 ppump nozzles, Denny T2 pin.
85 D350 single wheel, converted to cummins, getrag, turned up 2 turns and afc screw flush.
-
DodgeFreak - 14mm rotor
- Posts: 1701
- Joined: Sat May 15, 2010 8:14 pm
- Location: Iowa
Re: Wastegate actuator ?
by Black93 » Fri Feb 28, 2014 8:18 pm
This is a 60mm hx35. I just swapped the exh housing from my old wh1c, they were both 12cm.
1993 W350 LE ext. cab dually, tuned pump, 60mm HX35, NV4500, 4" straight tbe, 366, 1/8" bump, THD fuel pin & lppp, DPS manifold, DFI 5x12's, 3" tubes, PS IC, D80 rear, 3.54's, 4th gen Alcoas.
-
Black93 - fuel screw!!!!
- Posts: 231
- Joined: Mon Aug 17, 2009 10:33 am
- Location: TN