by GLHS » Tue Feb 05, 2008 11:45 am
Might be getting a little closer to finding one.
Would you happen to know if that was a manual transmission?
All the autos I have found so far are 1350 for the Fords.
Went to QUAD 4x4's site and learned the front u-joints in our 1st gens are 7260 (close to a 1310) except 93 which went to the bigger 7290 (close to a 1350) and the cv are similar but a little smaller than 1350's.
Part numbers for the Ford front driveshafts I've found are 5C3Z-4A376-F for the 1350 automatics.
The 5C3Z-4A376-E is for the manuals, which I have not run across yet.
Brian, you got part numbers for the 1350 and 1410 yoke size for the front D60 and how about a 1480 for a D80 and D70 rear?
92 W250 ext cab, 5spd, SPS 62/71/14, ATS 3 piece, Banks 3G intake, Icebox CAI, DDP #4+, timing 1.95 mm, SB 4 puck FE, PDR fuel pin, Hellmann intercooler, Snow water/meth, 60# springs, stock long block, D80 3.54 w/disks, 455+/1005 uncorrected, 13.34@102 7-06; 472 fuel/520 water/meth uncorrected 5-08